SPONSORED LINKS

2007 Suzuki Reno clutch

Tiny
LILVAL
  • MEMBER
  • 2007 SUZUKI RENO
  • 2.2L
  • 4 CYL
  • 2WD
  • MANUAL
  • 116,000 MILES
Was stopped at a red light, tried to to pull out from red light, clutch pedal was stuck on floor, car is stuck in gear, can physically raise clutch pedal, is the problem the master cylinder for clutch or is the clutch out?
Wednesday, March 18th, 2015 AT 2:57 PM

4 Replies

Tiny
CATAFINA
  • MECHANIC
  • 168 POSTS
Start by checking the clutch master cylinder and the slave
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Wednesday, March 18th, 2015 AT 3:53 PM
Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
If it stuck to floor I'd say it would be the clutch because if you let off the pressure from pedal the pressure plate would force the release bearing out. Try to shift it with engine off if it shifts then it's probably the clutch also look to see if rod on slave cylinder is fully extended.
Was this
answer
helpful?
Yes
No
-1
Wednesday, March 18th, 2015 AT 4:00 PM
Tiny
LILVAL
  • MEMBER
  • 2 POSTS
Where is the master cylinder located for clutch?
Was this
answer
helpful?
Yes
No
Wednesday, March 18th, 2015 AT 8:34 PM
Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
We dont' have apic of the master cylinder look on firewall. Below reservoir. Check to make sure it'snot a linkage problem
Was this
answer
helpful?
Yes
No
-1
Thursday, March 19th, 2015 AT 5:43 AM

Please login or register to post a reply.

Related Transmission Clutch Pedal Content

Sponsored links