Cruise control not working

ONEPHAT66

MEMBER
2007 NISSAN XTERRA
4.0L
6 CYL
4WD
AUTOMATIC
110,000 MILES

The cruise control will not turn on. When the problem first started you could only turn the cruise on (not set, but turn on), when turn the steering wheel 90 degrees or more to the left. Since then it will not turn on at all. I've replaced the brake switch with no change. I believe it's the clock spring, but would like to be certain before tearing apart and spending the money to buy a clock spring.

Monday, December 17th, 2018 AT 9:59 AM

3 Replies

KEN L

MASTER CERTIFIED MECHANIC
54,137 POSTS

Yep, you hit it the clock springs go out all the time. here is a guide to help walk you through it and diagrams below so you can see the repair is done on your car:

https://www.2carpros.com/articles/steering-wheel-clock-spring-removal

Check out the diagrams (below). Please let us know what happens.

Cheers, Ken

Images (Click to make bigger)

Was this

answer

helpful?

Yes

No

+2

Wednesday, December 19th, 2018 AT 12:32 PM

ONEPHAT66

MEMBER
20 POSTS

Thanks Ken. You're probably going to like to hear this, but we took the Xterra to go get. Dinner this evening and it popped a P1564 code when pulling out of the driveway. I can get the DTC light to go off, but my scanner still says there's a code stored (I'm assuming it's assuming bad enough issue it won't completely clear). I have a question regarding the new clock spring. I've seen for this vehicle, the entire multiswitch assembly for a replacement as well as just the click spring by itself. Question I have is without having the old one removed, do you know if the old clock spring is removable from the rest of the switch assembly? Even Nissan OEM pictures show both for this exact same vehicle, and obviously just the clock spring alone is much cheaper. Thanks again Ken. Jim

Was this

answer

helpful?

Yes

No

Wednesday, December 19th, 2018 AT 6:04 PM

KEN L