I have Mazda 6, 2, 3 it is no oil coming to oil control valv. What shall I do?

Tiny
KAISER SADIK
  • MEMBER
  • 2007 MAZDA 6
  • 140,000 MILES
Hi!
i have been changed the variable valv timing actuator because its knacked
so hard, but the new one also damaged and knckes. When I inspect the oil
flowed I discoverd there is no oil coming to ocv. But the oil is going evrything in engin. What shall I do or can you send me a picture or Explanatory scheme for vvt actuator lubrication.
thanks in advance.
Do you
have the same problem?
Yes
No
Sunday, December 18th, 2011 AT 6:55 PM

7 Replies

Tiny
KAISER SADIK
  • MEMBER
  • 4 POSTS
Hi!
I would thank you for your answer, its included very useful information.
But I asked about the engine oil it´s not runing from oil control valv which feed the variable valv actuator. There is no oil coming from the hole in cylinder head when you cranking.
I mean I need scheme over lubication system.
Thanks.

Kaiser
Was this
answer
helpful?
Yes
No
Tuesday, December 20th, 2011 AT 4:23 PM
Tiny
FIXITMR
  • MECHANIC
  • 9,990 POSTS
Have you tried some compressed air thru hole?
Was this
answer
helpful?
Yes
No
Wednesday, December 21st, 2011 AT 8:20 AM
Tiny
KAISER SADIK
  • MEMBER
  • 4 POSTS
Hi!
I tried give this hole compressed air manytime. The hole have just
tow canal, one located in the front engine side and this closed by the front engine cover. The second located under cylinderhead and this closed by cylinderhead gasket. I wonder which way takes oil this valv. I attach files to show you situation.

Best greeting
kaiser
Was this
answer
helpful?
Yes
No
Thursday, December 22nd, 2011 AT 10:21 PM
Tiny
FIXITMR
  • MECHANIC
  • 9,990 POSTS
Any hole in block under gasket? Does side cover block hole tight? What sits on/over OCV? Is OCV a drain/reducer not a pressure point?
Was this
answer
helpful?
Yes
No
Friday, December 23rd, 2011 AT 4:34 AM
Tiny
FIXITMR
  • MECHANIC
  • 9,990 POSTS
If you plug the 2 holes does air go anywhere else? Can you take close up pics of valve?
Was this
answer
helpful?
Yes
No
Friday, December 23rd, 2011 AT 5:00 AM
Tiny
KAISER SADIK
  • MEMBER
  • 4 POSTS
Hi
I want to thank you, because I have been told what's wrong in
the engine. It was a wrong head gasket which was sat on the engine and close the oil hole.
Thanks so much you have been very helpful.
Bye
Was this
answer
helpful?
Yes
No
Sunday, January 1st, 2012 AT 8:33 PM
Tiny
FIXITMR
  • MECHANIC
  • 9,990 POSTS
I actually had that in mind but thought you might be offended if I said that?
Was this
answer
helpful?
Yes
No
Monday, January 2nd, 2012 AT 5:41 AM

Please login or register to post a reply.

Sponsored links