2007 Ford Fusion AC

Tiny
JHUDDLESTON43
  • MEMBER
  • 2007 FORD FUSION
  • 2.4L
  • 4 CYL
  • FWD
  • AUTOMATIC
  • 150,000 MILES
AC clutch wont engage. Took the car to the shop and they said we need to replace the compressor. Did that and clutch still wont kick on. We are getting power to the relay but no power at the harness on the compressor. Ran power to the old compressor and you can hear it engage. New compressor wont take and refrigerant because the clutch wont engage. My thought was the evap temp sensor but we had it tested and it pulled no codes for any sensors. Im at a loss here and out 400 bucks because the shop was wrong. Please help.
Do you
have the same problem?
Yes
No
Friday, July 10th, 2015 AT 9:51 AM

1 Reply

Tiny
HMAC300
  • EXPERT
You might have a fuse boxl problem where relay is not getting good contact so try to adjust the prong to hit better in the fuse box. See pic then see if the wire going to compressor is getting power it should if relay works.
Was this
answer
helpful?
Yes
No
+3
Friday, July 10th, 2015 AT 12:57 PM

Please login or register to post a reply.

Recommended Guides