Brake pedal goes to floor, all wheels for leaks

Tiny
LUISBR71
  • MEMBER
  • 2006 TOYOTA CAMRY
  • 50,000 MILES
I instaled a new master cylinder on my 06 camry and bled cylinder and all wheels and pedal still go to the floor, no leaks on wheels or lines what im doing wrong. Break pedal goes to floor have checked all wheels for leaks. Replace master cylinder and bleed all lines and pedal still goes to the floor
Do you
have the same problem?
Yes
No
Monday, March 5th, 2012 AT 1:12 AM

1 Reply

Tiny
DRCRANKNWRENCH
  • EXPERT
Follow this procedure for bleeding brakes.

The right rear is farthest from the master cylinder and it takes along time to get fluid to pump to it especially with a new master cylinder.
To bench bleed the master cylinder, it should have came with a kit to do this, but if not get some short brake lines that if bent around will connect to master cylinder outlets and then cut off the other end so that it will reach the bottom of the master cylinder reservoir. Then make sure the fluid level never gets low in any of the bleeding process. Now pump kind of rapidly at the master cylinder for a while and then pump it normally until there are no air bubbles coming out of the holes in the bottom of each reservoir.

Now to bleed the brakes you need to get some pliable clear tubing that you can get at Home Depot. It needs to fit snugly over the bleed nipple and be long enough to run it over something that will hold its highest point above the caliper and then run it into a plastic bottle or jug till the hose goes to the bottom.
Start bleeding at the farthest caliper away from master cylinder and work closer to it. So, the right rear first, the drivers rear second, right rear third and then the drivers side front.

Fit one end over the bleed screw and run the line higher than the bleed screw then into the bottle. Put a little axle grease on the threads and once you get some of the air out, you can just keep flushing fluid without stopping to hold and release and tighten bleed screw. Since you have so many issues, I would suggest flushing it until it comes out clean.

Starting at the right rear caliper, (This is the farthest from the master cylinder and needs to be done first.)Pump and hold but you can also just pump if the level in the master cylinder is dropping. It takes a while to get fluid going from such a far place especially with a new caliper. To create the pressure to get the fluid going, it has to fill a large cavity the the master cylinder is not designed for. The master cylinder only moves a little bit of fluid when you use your brakes. So be patient, it will come.
If the pedal gets hard to pump, there is contamination somewhere and is often in the bleed screw. Remove it and clean it out.

Now move on to the drivers' side rear brake. Then the passenger side front brake. Then lastly the drivers front brake.

This system of working farthest away from the master cylinder to the closest helps remove the most contamination and helps more fluid to move along.
ALSO, never let the master cylinder get below the low mark. That will pump air into the brakes. If you think bleeding the farthest caliper is hard, a master cylinder is a killer to bleed.
Was this
answer
helpful?
Yes
No
-1
Monday, March 5th, 2012 AT 1:55 AM

Please login or register to post a reply.

Recommended Guides