• Tiny
  • changte
  • 2006 Mitsubishi Magna
  • 6 CYL
  • FWD
  • manual

I want to replace clutch kit, but the gear box can't pull out.
I check the new kit, found the bearing will lock on the pressure plate when box fit in.
now I am stuck, the fork is stuck there too,
someone could help me? Urgent.

Do you
have the same problem?
Saturday, August 13th, 2011 AT 1:29 AM

1 Reply

  • Tiny
  • mhpautos
  • Expert
  • 30,638 posts

This will by a "pull type clutch" I presume that you are in Aust? As Magna is not on the US market, looking at the US data base for Mitsubishi, I can see pull type clutches that are used, with these you remove the slave cylinder, and remove the dust boot over the clutch lever, looking in side you should see a clip that locks the fork onto the pivot, pull this clip and the fork will remove out of the thrust and the box will then be free to remove.

Was this
Saturday, August 13th, 2011 AT 6:06 AM

Please login or register to post a reply.

Similar Questions