2006 Ford Fusion codes keep coming back

2006 FORD FUSION
100,000 MILES • 2.3L • 4 CYL • FWD • AUTOMATIC
Avatar
ANDERSONBRYAN19
I keep getting code p0420 and code p0010 when I scan my fusion, I replaced the cam shafts positioning sensor and the upstream 02 sensor and cleared the codes but when I drive the car then stop and start it again the codes come right back, don't know what I'm over looking, any ideas? Oh and the car runs fine so I don't think it's the catylac converter being clogged.
Oct 26, 2015 at 11:18 AM
Advertisement
Avatar
WRENCHTECH
  • ✓ASE Certified Mechanic
  • 20,761 POSTS
  • ASE Certified Mechanic
The converter does not have to be clogged to be bad. the code means it's just not chemically doing it's job.
The other code is for a cam actuator circuit. Nothing to do with a cam position sensor
Oct 26, 2015 at 4:37 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.