4x4issue

Tiny
DGOLDENBERG1213
  • MEMBER
  • 2006 DODGE TRUCK
  • 98,000 MILES
06 2500 power wagon, 5.7 hemi, 4x4
service 4x4 light is on, says I'm in 4x4 mode when I'm not.
The switch for the front electric sway bar, continually flashes
and does not turn on or off, just blinks.

Thoughts please?

Thank You
Dave, G.
dgoldenberg1213@hotmail. Com
Do you
have the same problem?
Yes
No
Thursday, September 22nd, 2011 AT 12:57 AM

3 Replies

Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 108,005 POSTS
You need to have the computer scanned to identify where the problem is coming from. Chances are there is a sensor that is bad.
Was this
answer
helpful?
Yes
No
Thursday, September 22nd, 2011 AT 1:05 AM
Tiny
DGOLDENBERG1213
  • MEMBER
  • 17 POSTS
Is there a scanner I can buy for this, my ob2 scanner works on engine and other codes, but is not picking up the drive train?
The dealer wants way to much to do just the dio;
I have seen some blogs about re-flashing the drive train on dodges, but the dealer also wants an arm and leg to do this, can I reflash and upgrade the firmware/program myself?
Thanks again
Dave, G.
Dgoldenberg1213@hotmail. Com
Was this
answer
helpful?
Yes
No
Thursday, September 22nd, 2011 AT 1:34 AM
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 108,005 POSTS
Yes, but they are very expensive. They read everything from engine, AC, trans, ABS.
Was this
answer
helpful?
Yes
No
Thursday, September 22nd, 2011 AT 2:03 AM

Please login or register to post a reply.

Sponsored links