BECOME A MEMBER
Sign up with Facebook
I agree to the
Login with Facebook
NOT A MEMBER?
How can I remove one of the 5 bolts that hold the intake manifold top and bottom halves together?
2006 CHRYSLER PT CRUISER
I'm able to remove the other 4 bolts, but the one remaining one just turns and does not loosen or tighten.
have the same problem?
Monday, February 20th, 2012 AT 11:02 PM
You gonna have to force it out and then tap/die it later on or whatever? You have to do
Monday, February 20th, 2012 AT 11:08 PM
Youll need to drill the head off the bolt
Monday, February 20th, 2012 AT 11:09 PM
to post a reply.
Related Intake Manifold Bolt Torque Questions
O2 Sensor And Fuel Trim
This Is A Technical Question. Why At Fully Open Throttle The O2 Sensor Goes Rich Does It Stay Rich All Time When The Throttle Is Fully...
2006 Chrysler Pt Cruiser Back Probe
What I Should Use To Back Probe The Pt Cruiser Pcm Without Damaging Or Sprading The Connectors
2006 Chrysler Pt Cruiser Pcm
I Want To Shop For A Pcm Where Can I Get An Affordable One. I Have Seen Some Onlines For 200 Dollars But Those Companies They Have Bad...
Location Of The Engine Sensor To Change It
I Have Had My Thermostat Changed, The Housing, Motor Mounts, Spark Plugs, Timing Belt, And Water Pump Changed. I Am Getting An Error...
Ask a Car Question. It's Free!
Intake Manifold Replacement
Intake Manifold Replace Mercedes Benz C230
Find a car manual for your car
© 1999 - 2017 2CarPros, Inc.