Problems removing ignition switch

TAGG

MEMBER
2005 FORD EXPEDITION
134,000 MILES

I have had a problem with the starter not stopping when I start the engine when I remove the key to turn off the vehicle. I have replaced the starter and both fuses/relays and now am trying to replace the ignition switch. Is there a "trick" to removing the top and bottom "shrouds?" On the steering column so I dont have to remove the steering wheel? Am I going the correct direction with this line of repairs? Thanks Lee

Friday, December 2nd, 2011 AT 7:20 PM

1 Reply

RASMATAZ

MECHANIC
75,992 POSTS

Removal and Installation
Remove the steering wheel. For additional information, refer to STEERING COLUMN.
NOTE:Lower tilt release handle to access second screw.

Removing Lower Steering Column Shroud
Courtesy of FORD MOTOR CO.
Remove the lower steering column shroud.
Remove the screws.
NOTE:The screw is located behind the multifunction switch.

Removing Upper Steering Column Shroud Screw
Courtesy of FORD MOTOR CO.
Remove the screw and the upper steering column shroud.
Remove the bolt, push the release and position the multifunction switch aside.
Removing Multifunction Switch Bolt
Courtesy of FORD MOTOR CO.
Disconnect the ignition switch electrical connector.
Disconnecting Ignition Switch Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the ignition switch.

Was this

answer

helpful?

Yes

No

Friday, December 2nd, 2011 AT 7:42 PM