SPONSORED LINKS

Put a brand new battery in a couple weeks ago.

Tiny
JERPETERS
  • MEMBER
  • 2004 JEEP WRANGLER
  • 50,000 MILES
Put a brand new battery in a couple weeks ago, started and drove fine the few times it was a drove. Now I can't get nothing when turning the key. Battery is on slow charge, doesn't look like it will get above 25%. When I first hooked the charger up, there was a ticking noise for a few seconds from somewhere in the engine compartment.
SPONSORED LINKS
Thursday, April 11th, 2013 AT 3:06 PM

2 Replies

Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
Charge the battery and then have it tested. Just because it's new doesn't mean it's any good. Most auto parts do this for free. If it 's new it will be under warranty. If it's a diehard from sears they have to go a year normally because they fail anytime before that. The clicking was probably the starter solenoid making noise form poor contact or low power. Check to see if the fusible link form alternator is good, it can go out and you wont' get any charging, you only need a test light or volt meter and test it on the fuse in pdc and alternator.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Thursday, April 11th, 2013 AT 10:33 AM
Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
For some reason the pic didn't go on
Was this
answer
helpful?
Yes
No
Thursday, April 11th, 2013 AT 10:34 AM

Please login or register to post a reply.

Related Battery Charge Content

How to Charge a Car Battery
VIDEO
How to Charge a Car Battery
Instructional repair video
Battery Charge
GUIDE
Battery Charge
It is common for a battery to go dead for a few reasons in which case the battery will need to be charged. One of the most common causes for a dead battery is that it has...
VIEW MORE

Sponsored links