Heater fan motor

BLOWER MOTOR
Up under the dash on the passenger side is the location of the motor, remove the right kick panel, peel back the rug, remove the plugs, then the blower.

Removal and Installation

1. Remove the RH lower A-pillar trim panel.
2. Position aside the carpet below the blower motor.
3. Remove the blower motor (19805)
1. Remove the blower motor screws.
2. Disconnect the blower motor electrical connector.
3. Remove the blower motor.
Fig. 207: Removing Blower Motor
Courtesy of FORD MOTOR CO.
4. Remove the blower motor wheel (18504).
1. Remove the clip.
2. Remove the blower motor wheel.
Fig. 208: Removing Blower Motor Wheel
Courtesy of FORD MOTOR CO.
5. To install, reverse the removal procedure.