NEED TO KNOW HOW TO GET TO THE RAMPR EVAP VENT ...

  • Tiny
  • Anonymous
  • 2004 CHEVROLET MONTE CARLO
  • 71,288 MILES

Need to know how to get to the r&r evap vent solenoid for a 2004 Chevy Monte Carlo SS

Sunday, November 11th, 2012 AT 10:30 PM

1 Reply

  • Tiny
  • ASEMaster6371
  • EXPERT
  • 25,554 POSTS

REMOVAL PROCEDURE

Raise and support the vehicle. Refer to Vehicle Lifting.
Disconnect the evaporative emission (EVAP) vent valve electrical connector (1).
Remove the EVAP vent valve bracket bolt.
Remove the vent hose (4) from the EVAP vent valve.
Remove the EVAP vent valve from the bracket (2).

INSTALLATION PROCEDURE

Install the EVAP vent valve to the bracket (2).
Install the vent hose (4) to the EVAP vent valve.
Install the EVAP vent valve and the bracket.

NOTE: Refer to Fastener Notice in Service Precautions.

Install the EVAP vent valve bracket bolt.

Tighten
Tighten the bolt to 10 N.M (89 lb in).

Connect the EVAP vent valve electrical connector (1).
Lower the vehicle.

Was this
answer
helpful?
Yes
No
Sunday, November 11th, 2012 AT 10:44 PM

Please login or register to post a reply.

Other Vent Questions