how do you prime hydrolic clutch

2003 ALL OTHER MAKES RECREATIONAL VEHICLES
Avatar
MATTLWOOD
  • MEMBER
  • 1 POST
How do you prime hydrolic clutch
Jun 6, 2012 at 4:58 PM
Advertisement
Avatar
RIVERMIKERAT
  • CAR REPAIR CONTRIBUTOR
  • 6,110 POSTS
Open the bleeder valve on the slave cylinder until fluid comes out. Close it. Pump the pedal 5 or 6 times. Hold the pedal down and open the bleeder valve again. Repeat until all air bubbles are out, refilling the master as required.
Jun 6, 2012 at 5:33 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.