2003 Jeep Liberty speedometer an radio

Tiny
SAVANNAH_HICKERSON
  • MEMBER
  • 2003 JEEP LIBERTY
  • 173,441 MILES
We remove the radio and replace it with a aftermarket radio. When we done this the speedometer stop working and the wipers also stop working. We cut the wires of the old radio and just wired them up to the new radio. My boyfriend also ran a wire from my wiper to make them work on one speed where I have to put the wires together inside and than undo them to turn them off. So we do not know where to go now. Can you please help me get my jeep back together and working right?
Do you
have the same problem?
Yes
No
Friday, October 4th, 2013 AT 9:07 AM

6 Replies

Tiny
HMAC300
  • EXPERT
First there shold be adapters that you can buy so you just plug the radio in and not cut wires. That is your first problem. The yellow wire to yellow violet should be hooked back up because it goes to the bcm that may fix your problem
Was this
answer
helpful?
Yes
No
Friday, October 4th, 2013 AT 9:54 AM
Tiny
HMAC300
  • EXPERT
Oh and if you have aproblem in the future just have your boyfriend drive it to a pro who can do things right.
Was this
answer
helpful?
Yes
No
Friday, October 4th, 2013 AT 9:55 AM
Tiny
SAVANNAH_HICKERSON
  • MEMBER
Thank you. We try to hook the yellow and the yellow violet back together and everything on the dash stop working. What does that mean?
Was this
answer
helpful?
Yes
No
Friday, October 4th, 2013 AT 10:00 AM
Tiny
HMAC300
  • EXPERT
You might have a screwed up bcm which is expensive to replace. Have apro look at this and see if he can get it fixed right so everything will work again. Even if you have to put the old radio back in then get an adapter or have a radio shop install it.
Was this
answer
helpful?
Yes
No
Friday, October 4th, 2013 AT 10:02 AM
Tiny
SAVANNAH_HICKERSON
  • MEMBER
When we hook the old radio up it would not come on. Do you think if I get the adapters or a wiring kit for it do you think that will help any? With the wires already cut?
Was this
answer
helpful?
Yes
No
Friday, October 4th, 2013 AT 10:06 AM
Tiny
HMAC300
  • EXPERT
Dowhat I said in last reply you may have to reset a code for radio if it's that type then try your last 4 digits of vin number on dash. Otherwise call Chrysler for the code. You'll need the vin. But really have a pro do this NOT your bf because it needs to be hooked up correctly because there is also a pci bus included.
Was this
answer
helpful?
Yes
No
Friday, October 4th, 2013 AT 10:08 AM

Please login or register to post a reply.

Recommended Guides