I got a P0101 on my scantool

Tiny
EVA_ADAZA
  • 2003 HUMMER H2
  • 4,500 MILES

I got a p0101 on my scantool. Engine rpm is too high. At cold start it reaches 1500 rpm and in a few minutes will rev high to 2500-3000 rpm and it stays there. I replaced the air filter, MAF sensor and the MAP sensor but still didn't fixed the problem. I also used BG air induction cleaner on the throttle body but still didn't solve the problem. Replaced also the spark plugs and did a change oil. Need help. Thanks

Do you
have the same problem?
Yes
No
Wednesday, January 23rd, 2013 AT 3:09 PM

2 Replies

Tiny
SATURNTECH9
  • EXPERT
  • 30,638 POSTS

I would first check for vacuum leaks with the syptoms you have with that high idle.A vacuum leak can cause a high idle and skew the map reading and set that code. Also make sure the air inlet tube isnt leaking.

Please consider a donation to help us answer more questions.
Was this
answer
helpful?
Yes
No
Wednesday, January 23rd, 2013 AT 5:36 PM
Tiny
SATURNTECH9
  • EXPERT
  • 30,638 POSTS

Also pull the vacuum line off the fuel pressure regulator and see if its leaking fuel into the vacuum line?

Please consider a donation to help us answer more questions.
Was this
answer
helpful?
Yes
No
Wednesday, January 23rd, 2013 AT 6:01 PM

Please login or register to post a reply.

Related MAP Sensor Replace/Remove Questions

Help us by donating