BECOME A MEMBER
Sign up with Facebook
I AGREE TO THE
Login with Facebook
BECOME A MEMBER
HOW DO YOU BLEED THE CLUTCH AT THE BELT HOUSING?
2003 Holden Ute
We have replaced the clutch and bled it everywhere except at the belt housing. We are having trouble working out how to bleed it there is not much room to do it. Any ideas?
have the same problem?
Monday, September 5th, 2011 AT 11:14 PM
The slave cylinder is at the bell housing. Open the bleeder and allow gravity to bleed it. After that, you may want to try manually bleeding the system, but it shouldn't need it.
Tuesday, September 6th, 2011 AT 2:19 AM
to post a reply.
2000 Hyundai Tiburon. How Hard Is It To Replace The Clutch On This Car And What Is Involved In The Process
I Too Can't Get The Release Bearing To Release Tyring ...
I Am Trying To Replace The Clutch And Can't Get The Release Bearing To Release From The Diaphragm Fingers On This Pull Type Clutch. Is There...
Changed Clutch , Won't Go Into Gear
The Truck Is A F350 4x4 6.8l. I Replaced The Clutch, Pressure Plate, Throwout Bearing, Pilot Bearing, And Cut The Fly Wheel. After ...
2005 Mitsubishi Lancer Es Clutch Removal Instillation
I Need To Know How To Change A Clutch In A 2005 Mitsubishi Lancer Es. 5 Speed, Front Wheel Drive, 2.0 L. There Is No Haynes Manual ...
Found 858 related questions
How To Replace A Clutch On Air Conditioner
How Do I Remove The Clutch Starter Safety Switch?
How To Removing Clutch Interlock Switch
Ask a Car Question. It's Free!
Clutch/Flywheel/Rear Main Seal Replacement
Need To Replace Your Clutch? See How The Pros Do It
Pilot Bearing Making Noise? Replace It Like The Pros
Find a car manual for your car
© 1999 - 2016 2CarPros, Inc.