I cant figure out what to change, the speed.

Tiny
ANONYMOUS
  • MEMBER
  • 2003 CHRYSLER CONCORDE
  • 125,000 MILES
I cant figure out what to change, the speed sensors or the whole transmission. It would occasionally quit shiftinggears while driving but if I pulled over and shut the car off and restarted it, it would be fine for a few. I recently changed the filter and fluid and then it wouldnt go into gear at all unless I rev the engine up really high but as soon as I let off the gas, it wouldnt go into gear
Tuesday, March 12th, 2013 AT 5:05 AM

2 Replies

Tiny
RANDICO
  • MECHANIC
  • 174 POSTS
This is a slipping transmission, The speed sensor not at fault, The reason is it would not go in gear unless I rev the engine, When you rev the engine up you increase fluid pressure, allowing the torque convertor to do its job, the transmission is over the hill.
Was this
answer
helpful?
Yes
No
Tuesday, March 12th, 2013 AT 5:48 AM
Tiny
ASEMASTER6371
  • MECHANIC
  • 52,796 POSTS
You need to either have it re built or replaced.

It is going into limp mode due to an internal failure

Roy
Was this
answer
helpful?
Yes
No
Tuesday, March 12th, 2013 AT 6:49 AM

Please login or register to post a reply.

Related Transmission Input Shaft Sensor Replace/Remove Content

VIEW MORE