SPONSORED LINKS

2003 Buick Century wont stay running

Tiny
THOMAS32
  • MEMBER
  • 2003 BUICK CENTURY
Century, Jusr Replace Fuel Pump, Filter, Pressure Regulator, Spark Plugss And Wires What Is The Problemjust replaced all these parts car will not stay running the car will run but once I apply the brake it dies out but if I restart it will stay started but I also just had a new radio and speakers installed the same day car stop on me dont think this is the problem had radio installed before with no problems
SPONSORED LINKS
Saturday, April 21st, 2012 AT 4:26 PM

11 Replies

Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
Are you saying the car won't start? Will it crank? Any applicable trouble codes?
Was this
answer
helpful?
Yes
No
Saturday, April 21st, 2012 AT 4:31 PM
Tiny
THOMAS32
  • MEMBER
  • 24 POSTS
The car is not starting the codes are b1216 b1221 b1225 b1232 b1236 b1295 it was cranking but after getting to autozone and get the codes it stop no crank no nothing
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Saturday, April 21st, 2012 AT 4:37 PM
Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
So you drove it to autozone? Make sure the battery has a full charge and battery connections all clean and tight. Check the starter circuit.
Was this
answer
helpful?
Yes
No
Saturday, April 21st, 2012 AT 4:42 PM
Tiny
THOMAS32
  • MEMBER
  • 24 POSTS
Ok its running now but if u step on the brakes or cut on the lights its cutting off then I start it back up and the same thing brake or lights it shut off what could rhat be
yes I drove it to auto zone thats were it shut off at
where is the starter circuit
Was this
answer
helpful?
Yes
No
Saturday, April 21st, 2012 AT 4:49 PM
Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
I couldn't find those codes in MOD. I did find some of those codes in a generic list, did not have codes listed according to year--make--model. I can't be sure they pertain to your vehicle? You might check the computer for voltage and grounds.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Saturday, April 21st, 2012 AT 5:03 PM
Tiny
THOMAS32
  • MEMBER
  • 24 POSTS
No these are the codes they gave me I think its a wiring problem just removed the radio and hook it back up but all lights came on like normal but soon as I hit the brakes it turned off I think wiring maybe check voltage and grounds on what part
Was this
answer
helpful?
Yes
No
Saturday, April 21st, 2012 AT 5:06 PM
Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
The starter S terminal goes hot with key in the crank position. The starter B terminal is hot all the time. Any testing, make sure the tranny is in park or neutral and the e-brake is set.
Was this
answer
helpful?
Yes
No
Saturday, April 21st, 2012 AT 5:16 PM
Tiny
THOMAS32
  • MEMBER
  • 24 POSTS
So are u saying I need to start it up and leave it in park with the emergency brake in place if it stays started what does that mean and if it cuts off what is that so does that mean it the starter or am I checkin to see if the starter is going hot
Was this
answer
helpful?
Yes
No
Saturday, April 21st, 2012 AT 5:22 PM
Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
You only need to check starter circuit circuit, if it won't crank. Otherwise, I don't know.
Was this
answer
helpful?
Yes
No
Saturday, April 21st, 2012 AT 5:48 PM
Tiny
THOMAS32
  • MEMBER
  • 24 POSTS
Ok thanks
Was this
answer
helpful?
Yes
No
Saturday, April 21st, 2012 AT 6:01 PM
Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
Let us know what you find?
Was this
answer
helpful?
Yes
No
Friday, May 4th, 2012 AT 5:01 PM

Please login or register to post a reply.

Related Engine Stall While Driving Content

Is it Safe to Drive Check Engine Light?
VIDEO
Is it Safe to Drive Check Engine Light?
Instructional repair video
Engine Stalls While Driving
GUIDE
Engine Stalls While Driving
An engine that stalls while driving and then starts back up again, either immediately or after a short time is different from an engine that just wont start or if the...
VIEW MORE

Sponsored links