The car runs fine and engine temp is normal but.

  • 110,000 MILES
The car runs fine and engine temp is normal but get no heat from vents. Was working yesterday then not work last nite or today. Coolant level is fine and recently had timing belt, water pump & thermostat replaced. Any suggestions?
Saturday, March 16th, 2013 AT 11:53 PM

1 Reply

With the engine at full operating temp, locate the 2 heater hoses where they go into the firewall and feel them to see if they are both hot to the touch. If not too hot to hold, then you have to look at the actual engine temp and if that is up, if it is, then your looking at a restricted heater core.
If you find that they are both too hot to hold, then the heat in that vehicle is controlled by a blend door that regulates heated air flow. It is operated by an electric motor/actuator. The problem can be that the actuator is stripped or inoperative or the door itself could be damaged. This is what needs to be determined by examining the actuator and see if it is responding to heat change commands or not.
If they are both not too hot to hold on to, then you either have a restricted heater core or the system is not completely full and getting air pockets for some reason.
Was this
Saturday, March 16th, 2013 AT 11:55 PM

Please login or register to post a reply.

Recommended Guides