HUB & BEARING ASSEMBLY
Raise and support vehicle.
Remove wheel and tire assembly.
Remove hub nut and hub washer.
Remove ABS wheel speed sensor, if equipped.
Remove brake caliper and rotor.
Remove hub and bearing assembly mounting bolts from rear of steering knuckle.
Slide hub and bearing assembly off CV axle shaft splines.
Inspect steering knuckle grease seal and hub and bearing assembly for excessive wear and damage. Replace components as necessary.
Install hub and bearing assembly onto steering knuckle, guiding CV axle shaft through spline in hub. Tighten hub and bearing assembly-to-steering knuckle mounting bolts to specification.
Install brake rotor and caliper.
Install ABS wheel speed sensor, if equipped.
Install hub nut and washer, and tighten to specification. Install wheel and tire assembly.
Remove support and lower vehicle
Friday, March 12th, 2010 AT 10:06 PM