WHAT IS THE TORQUE SPECS FOR THE CAMSHAFT TOWER BOLTS 2.7 LITER 2002 INTREPID

  • Tiny
  • kat0421
  • 2002 Chrysler Intrepid

Need to know what the torque specs for the camshaft tower is

Friday, December 30th, 2011 AT 10:49 PM

5 Answers

  • Tiny
  • Wrenchtech
  • Expert
  • 19,802 posts

There are 3 different 2.7 engines. What is the 8th digit of the VIN#?

Was this
answer
helpful?
Yes
No
Friday, December 30th, 2011 AT 11:05 PM
  • Tiny
  • kat0421
  • Member

The 8th digit on vin is R

Was this
answer
helpful?
Yes
No
Saturday, December 31st, 2011 AT 12:02 AM
  • Tiny
  • Wrenchtech
  • Expert
  • 19,802 posts

Tighten the camshaft bearing cap bolts using the sequence shown to 12 Nm (105 in. Lbs.).

Was this
answer
helpful?
Yes
No
Saturday, December 31st, 2011 AT 12:06 AM
  • Tiny
  • kat0421
  • Member

What are the head bolts torqued at

Was this
answer
helpful?
Yes
No
Saturday, December 31st, 2011 AT 12:13 AM
  • Tiny
  • Wrenchtech
  • Expert
  • 19,802 posts

The head bolts are one time use and cannot be re-used.

The sequence is easy to figure. Always start in the middle and alternate side to side working to the ends.

Tighten bolts in sequence shown, using the following steps and torque values: Step 1: Bolts 1-8 to 48 Nm (35 ft. Lbs.)
Step 2: Bolts 1-8 to 75 Nm (55 ft. Lbs.)
Step 3: Bolts 1-8 to 75 Nm (55 ft. Lbs.)
Step 4: Bolts 1-8 an additional 1/4 turn. Do not use a torque wrench for this step.
Step 5: Bolts 9-11 to 28 Nm (250 in. Lbs.)

Was this
answer
helpful?
Yes
No
Saturday, December 31st, 2011 AT 12:17 AM

Please login or register to post a reply.

Similar Questions