WINDSHIELD WASHER TANK

  • Tiny
  • h20pigret
  • 2002 Chevrolet Blazer
  • 6 CYL
  • 4WD
  • automatic

Is there a written report on R & R a windshield washer Reservour on a 2002 Chevy Blaser. I am pretty sure that it's is cracked on the bottom.

Do you
have the same problem?
Yes
No
Monday, February 21st, 2011 AT 8:49 PM

1 Reply

  • Tiny
  • merlin2021
  • Expert
  • 17,587 posts

WASHER PUMP/RESERVOIR REPLACEMENT

Removal Procedure

1. Remove the washer solvent from the solvent container.
2. Disconnect the electrical connectors from the washer pumps.
3. Disconnect the hoses from the washer pumps.
Fig. 29: Locating Washer Pumps Hoses
Courtesy of GENERAL MOTORS CORP.
4. Remove the screw and the solvent container from the vehicle.
Fig. 30: Locating Solvent Container Screw
Courtesy of GENERAL MOTORS CORP.
5. Remove the washer pumps and grommets from the solvent container.
Fig. 31: Locating Solvent Container Washer Pumps & Grommets
Courtesy of GENERAL MOTORS CORP.
Installation Procedure

1. Install the washer pumps and grommets onto the solvent container.
Fig. 32: Locating Solvent Container Washer Pumps & Grommets
Courtesy of GENERAL MOTORS CORP.
2. Install the solvent container onto the vehicle with the screw.
Tighten
Tighten the screw to 3 N.M (27 lb in).
Fig. 33: Locating Solvent Container Screw
Courtesy of GENERAL MOTORS CORP.
3. Connect the hoses to the washer pumps.
4. Connect the electrical connectors to the washer pumps.
5. Refill the washer solvent in the solvent container.

Was this
answer
helpful?
Yes
No
Monday, February 21st, 2011 AT 8:53 PM

Please login or register to post a reply.

Similar Questions