2001 SATURN L200
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
I found an oil leak coming from the "oil pressure switch" but I can't seem to access it other than to disconnedt it. Do I have to pull the starter first? Please help.
Jan 18, 2013 at 12:41 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
ASEMASTER6371
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 52,796 POSTS
REMOVAL



Ignition Off.
Disconnect engine oil pressure (EOP) switch harness connector.
Remove EOP switch (use 11/16 inch deep well socket).

INSTALLATION



Apply RTV sealant (or equivalent) to the EOP switch threads.
Install EOP switch.

Torque:
Engine Oil Pressure Switch: 10 N.m (89 in-lbs)

Connect EOP switch harness connector. Push in connector until a click is heard, then pull back to confirm a positive engagement.
Check oil level and fill if low.
Start engine and check for leaks.


Jan 18, 2013 at 1:47 AM
Advertisement