CRANNKSHAFT AGNLE SENSER 2001 OLDMOBILE INTRIGUE

  • Tiny
  • keith_mannkl
  • 2001 Oldsmobile Intrigue
  • 4 CYL
  • automatic

How do u replace a crankshaft angel sensor for a 2001 oldsmobile intrigue?

Do you
have the same problem?
Yes
No
Sunday, March 20th, 2011 AT 11:39 PM

1 Reply

  • Tiny
  • rasmataz
  • Member

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
Disconnect the negative battery cable.
CAUTION: Refer to Vehicle Lifting Caution in Service Precautions.
Raise the vehicle.
Loosen or remove the starter motor (1) as necessary.
Disconnect the electrical connector from the crankshaft position (CKP) sensor (2).
Remove the CKP sensor mounting bolt (1).
Remove the CKP sensor (2) from the engine block:
Remove the sensor by pulling on the sensor connector.
Do not pry on the bracket. Do not rotate or twist the sensor or damage the mounting bracket if the sensor is being reused.

Was this
answer
helpful?
Yes
No
Sunday, March 20th, 2011 AT 11:47 PM

Please login or register to post a reply.

Similar Questions