SPONSORED LINKS

I replaced the crankshaft position sensor but it barely runs?

Tiny
CGARSKE
  • MEMBER
  • 2001 JEEP GRAND CHEROKEE
  • 4.0L
  • 6 CYL
  • 4WD
  • AUTOMATIC
  • 160,000 MILES
Not long enough to actually go anywhere and extremely rough. If I put the old one back in it will run. The reason I am replacing it is as soon as the car warms up the engine shuts off.
Monday, June 12th, 2023 AT 9:17 AM

1 Reply

Tiny
KEN L
  • MASTER CERTIFIED MECHANIC
  • 42,904 POSTS
It sounds like you have a defective sensor here is the instructions on how to change it out in case you need it and I have seen this sensor cause the engine to stall when hot, so I think you are on the right track. Check out the images (below). Please let us know what you find.
Image (Click to make bigger)
Thumb
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
-1
Monday, June 12th, 2023 AT 10:00 AM

Please login or register to post a reply.

Related Crankshaft Sensor Replace/Remove Content

Crankshaft Sensor Symptoms
GUIDE
Crankshaft Sensor Symptoms
Most modern car engines use a crankshaft sensor to monitor the engines crankshaft rotation. This sensor sends feedback information to the cars computer which then adjusts...
VIEW MORE

Sponsored links