HiWhen replacing O2 sensors do they have to be OE or can they be aftermarket?

Tiny
RIEBED
  • MEMBER
  • 2001 HYUNDAI ELANTRA
  • 197,000 MILES
Replaced post cat 2x and the check engine light is still on-also had wiring/voltage checked and all is ok-any ideas?
Do you
have the same problem?
Yes
No
Thursday, December 29th, 2011 AT 4:55 AM

3 Replies

Tiny
JACOBANDNICKOLAS
  • EXPERT
Have you reset the computer with a scanner? And yes, you can use an aftermarket.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Thursday, December 29th, 2011 AT 4:56 AM
Tiny
RASMATAZ
  • EXPERT
Joe-Joe, I prefer OEM not imitation, if its not the real deal I don't deal-its an options if you cannot afford the best, just hope it works like the best. You can confirm it if its doing its job by viewing the data stream of the scantool-
Was this
answer
helpful?
Yes
No
Thursday, December 29th, 2011 AT 5:30 AM
Tiny
JACOBANDNICKOLAS
  • EXPERT
That is my choice too, Raz. I agree, but can't always afford them.
Was this
answer
helpful?
Yes
No
Thursday, December 29th, 2011 AT 5:36 AM

Please login or register to post a reply.

Related Oxygen Sensor Replace/Remove Content

Oxygen Sensor Replacement
VIDEO
Oxygen Sensor Replacement
Instructional repair video
Oxygen Sensor Replacement
GUIDE
Oxygen Sensor Replacement
An oxygen or lambda sensor is used to determine the engine exhaust mixture which can then be controlled by the computer. These sensors are equipped with a heater that can...
VIEW MORE

Sponsored links