broken engine block

2001 GMC SIERRA
100,000 MILES • V8 • 4WD • AUTOMATIC
Avatar
ALAN
  • MEMBER
  • 2 POSTS
Hi,
I have a GMC Sierra 2500 (6.0L, 8 cyl.). The engine block is broken by cylinder failure. Plz. see the attached image. The hole is 4" long. I need to know if the engine is repairable?
Thank you,
Alan
Image (Click to enlarge)
Attached Media
Dec 3, 2010 at 7:51 PM
Advertisement
Avatar
CARADIODOC
  • CAR REPAIR CONTRIBUTOR
  • 34,310 POSTS
Blocks can be welded up but that is a real expensive procedure reserved for expensive industrial engines. It's not economically feasible for your truck. Plus, you still have the cost of repairing the original failure.

caradiodoc
Dec 3, 2010 at 7:54 PM
Avatar
ALAN
  • MEMBER
  • 2 POSTS
How about metal stitching? will it work? cheep?
Dec 3, 2010 at 7:59 PM
Avatar
CARADIODOC
  • CAR REPAIR CONTRIBUTOR
  • 34,310 POSTS
Welding cast iron requires heating it for a long time, probably hours, with a flame before welding or it will shatter. You'd have to ask the folks at an engine rebuilding and machining shop.

caradiodoc
Dec 3, 2010 at 8:05 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.