we have changed the blinkers on the turn signal and changed the switch andthe signals still arent working is there a second relay on this car
Dec 15, 2012 at 10:28 PM
2001 Chevrolet Cavalier Changed Blinkers On Turn Signal Switch Andthe Signals
2001 CHEVROLET CAVALIER
ANONYMOUS
- MEMBER
- 1 POST
- FOLLOW
Advertisement
no, did you check the fuse?? is there power to the switch??? is the connector ok?? melted??? are the bulbs all good????? do the arrow lights light up????
roy
roy
Dec 15, 2012 at 10:33 PM
did you try replacing the flasher?
The flasher sits above the gas pedal behind a small, black panel . The panel is held on with one star bolt and is situated between the gas pedall arm and the bottom of the plastic molding that sits below the steering column. the flasher should be be green and clipped to a small, cube shaped harness and attached to the inside wall by two plastic clips. You will need to use a very small flat head to pry the two pieces apart.
The flasher sits above the gas pedal behind a small, black panel . The panel is held on with one star bolt and is situated between the gas pedall arm and the bottom of the plastic molding that sits below the steering column. the flasher should be be green and clipped to a small, cube shaped harness and attached to the inside wall by two plastic clips. You will need to use a very small flat head to pry the two pieces apart.
Dec 15, 2012 at 10:50 PM
hey freemba, your good! these guys should hire you! put in your APP!
Dec 15, 2012 at 10:54 PM
did you not say in your original post you replaced the flasher relay??
roy
roy
Dec 15, 2012 at 10:58 PM
2 on 1995 1 on 2001
Jan 4, 2013 at 3:02 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.