When I floor the car wide open check engine.

Tiny
BROD1893
  • MEMBER
  • 2001 BMW 740
  • 143,301 MILES
When I floor the car wide open check engine light flashes I seems like loop status most of the time goes open never returns closed till car is shut off has and then has code p1345. Car operating temp 217, o2 sensors read when goes open loop otherwise fluctuates above and below. 450mv. Car has 150 compression on eight cyls. Smoke test shows no vacuum leaks. Has eight new plugs. New fuel filter. F. Inj. Serv. Was done. Car also seems to have a rythmic idle problem while driving. Any clue?
Do you
have the same problem?
Yes
No
Saturday, April 6th, 2013 AT 12:47 AM

3 Replies

Tiny
ASEMASTER6371
  • EXPERT
Flow chart

Roy
Was this
answer
helpful?
Yes
No
Saturday, April 6th, 2013 AT 12:57 AM
Tiny
BROD1893
  • MEMBER
Cant read flow chart on my tablet will have to go to bigger computer?Will keep you posted, thanks.
Was this
answer
helpful?
Yes
No
Saturday, April 6th, 2013 AT 1:00 AM
Tiny
DR. HAGERTY
  • MEMBER
I would look at the live data to start with, additive and multiplicative numbers, KG/air/minute, injector pulse width, and any relevant fault codes that wont erase. A flashing CEL can indicate converter damage and will send it into limp home mode.
Was this
answer
helpful?
Yes
No
Tuesday, April 9th, 2013 AT 7:26 AM

Please login or register to post a reply.

Recommended Guides