transmission wont shift into drive?

2000 MITSUBISHI MONTERO
222,000 MILES • 3.0L • 6 CYL • 4WD • AUTOMATIC
Avatar
DANIELK81
  • MEMBER
  • 1 POST
My montero wont shift in to drive and i just replace the range sensor?
Jan 18, 2015 at 9:44 AM
Advertisement
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
front wheel drive, 4wheel drive, all wheel drive rear wheel drive they are different
Jan 18, 2015 at 10:43 AM
Avatar
STRAILER
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 54,128 POSTS
If this problem happened after you replaced the gear range sensor then it is defective or not installed correct. We should run the codes though to make sure there are no codes, also check the transmission fluid level.

https://www.2carpros.com/articles/checking-a-service-engine-soon-or-check-engine-light-on-or-flashing

Here is the gear range sensor location to make sure we are on the same page. Check out the images (below). Let us know how it goes
.
Image (Click to enlarge)
Attached Media
Oct 13, 2024 at 2:21 PM
Advertisement