SPONSORED LINKS

ROUGH RUNNING

  • Tiny
  • redbone
  • 2000 Mazda MPV

Rplaced the mass air flow sensor cause it was bad. After I replced it the van would lope, then when it got up to operating temp the idle went real low.I shut off the van and when try to start it the van wont start unless you push the pedal all the way to the floor and crank the engine then it starts but goes to low idle and lopes.

SPONSORED LINKS
Do you
have the same problem?
Yes
No
Saturday, October 22nd, 2011 AT 8:09 PM

1 Reply

  • Tiny
  • rasmataz
  • Member

http://www.2carpros.com/articles/engine-misfires-or-runs-rough

1.Defective spark plugs

2.Inadequate spark/coil,defective spark plug wire.

3.Lack of compression

4.False air leakage.

5.Faulty fuel injectors.

6.Insufficient fuel pressure.

7.Contaminated fuel.

8.EGR valve that is leaking.

9.Oxygen sensors.

10.Throttle position sensor.

11.Manifold absolute pressure sensor

12.Mass Airflow Sensor

13.Idle air control valve

Note: If it doesn't apply disregard it-

SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Wednesday, October 26th, 2011 AT 8:29 AM

Please login or register to post a reply.

Similar Questions

B2200 Clutch Sticks All The Way To The Floor

Clutch Sticks All The Way To The Floor When Stopped For A While At Light. There Is A Master And Slave Clutch Cylinder. Is There A Spring...
Asked by sfalk ·
1 ANSWER

1991 Mazda B2200 Brake Pedal Goes To The Floor Before ...

1991 Mazda B2200 2.2l Mileage 180,000. When I Apply The Brakes The Pedal Goes Almost To The Floor Before The Brakes Engage, (when This ...
Asked by 2CarPros-Archives ·
1 ANSWER

Replaced Master Cylinder And Pedal Still Goes To Floor...

We Replaced Master Cylinder, Bench Baked It The Whole Nine Yards, When We Put It Back On The Car The Pedal Still Goes To The Floor. What ...
Asked by Amy Lou ·
8 ANSWERS
2 IMAGES

1991 Mazda Protege No Brake Pressure After Changing ...

Brakes Problem 1991 Mazda Protege 4 Cyl Front Wheel Drive Manual 172000 Miles I Started Changing My Brake Fluid Because It Was Brown ...
Asked by SwordsmanG ·
5 ANSWERS