SPONSORED LINKS

2000 Ford Taurus blend door actuator

Tiny
IGBED
  • MEMBER
  • 2000 FORD TAURUS
  • 3.8L
  • 6 CYL
  • FWD
  • AUTOMATIC
  • 170,000 MILES
I have a 2000 Ford Taurus. My issue is the AC/Heater blend door actuator is not changing state when the electronic control buttons are engaged. Is there another module that communicates between the two? Can you give me expected voltage readings at the pigtail that connects to the actuator?
SPONSORED LINKS
Tuesday, September 29th, 2015 AT 5:57 PM

1 Reply

Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
Pull fuse 232 in central junction box for 60 seconds with key on. See if resets. There should be about 5 volts going to it but it should be scanned by a pro to see If that is the actual problem the shaft may be broken from the door.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Wednesday, September 30th, 2015 AT 7:08 AM

Please login or register to post a reply.

Related Blend Door Actuator Replace/Remove Content

Blend Door Actuator Replacement
GUIDE
Blend Door Actuator Replacement
Do you hear a ticking noise from your dash when the ignition key is on? Does your car heater blow cold or the air conditioner blow hot? These are signs that a blend door...
VIEW MORE

Sponsored links