1999 OLDSMOBILE INTRIGUE
195,000 MILES
Avatar
MSLADYD08
  • MEMBER
  • 2 POSTS
My car will crank fine but when i put it into drive it doesnt go or in any othergear it wont move
Jan 23, 2013 at 2:38 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
check trans fluid make sure it's full, have a trans guy scan it for codes although sounds like internal damage
Jan 23, 2013 at 3:26 PM
Advertisement
Avatar
MSLADYD08
  • MEMBER
  • 2 POSTS
I put a new transmission filter and gasket on and 4 quarts of fluid in it drove fine after that then the next day i crunk it up put it in drive but it wouldn't go it started rolling backwards on its own. HELP!!!
Jan 24, 2013 at 3:56 PM
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
you'll probably have to pull the pan off again and see if the filter has come out of position or the Oring around it is leaking.
Jan 24, 2013 at 5:30 PM