BECOME A MEMBER
Sign up with Facebook
I agree to the
Login with Facebook
NOT A MEMBER?
1999 GMC SUBURBAN
How to change a serpentine belt on 1999 GMC suburban
have the same problem?
Sunday, November 14th, 2010 AT 5:14 PM
There should be a belt tensioner. Once you release tension, you take belt off pulley. The tensioner may have a square cutout, for a rachet drive or breaker-over.
Sunday, November 14th, 2010 AT 5:26 PM
The tensioner has a nut in the center. Do I loosen the nut? It looks like the nut holds the tension on
Sunday, November 14th, 2010 AT 5:52 PM
Sorry for the late reply, if there is a cut-out in the tensioner arm, view diagram, use the cut-out with rachet drive, maybe a 1/2 inch drive?
Tuesday, December 28th, 2010 AT 6:06 PM
to post a reply.
Related Serpentine Belt Replace/Remove Content
I Replaced Water Pump And Serpintine Belt On My 95 Suburban 4x4 Gas Engine But I Am Now Having Problems Keeping It Started In Reverse When...
Serpentine Belt Replacement
Step by step guide on how to replace an automotive serpentine belt, this information outlines the basic procedure which translates to most vehicles.
1999 Gmc Suburban Oil Pump
Are There Any Gaskets Or Seals On Or Near The Oil Pump That Could Fail & Leak Oil Into The Cooling System?
1999 Gmc Suburban Timing Chain
When To Chainge The Timing Chain I Own A 1999 Gmc Suburban With 145346 Miles
1999 Gmc Suburban Service Engine
When Light First Came On Code Was Pulled For Maf Sensor. Replaced. Driven Less Than 10 Miles, Light Comes On Again. Code Pulled Showing Bad...
Engine Swap From 5.7 To 5.7 Vortec
Engine Mechanical Problem V8 Two Wheel Drive Automatic 175000 Miles I Am In The Process Of Trying To Swap Out A Original 5.7 Engine In...
Ask a Car Question. It's Free!
Serpentine Belt Tensioner Replacement
Power Steering Pump Replacement
Low Oil Pressure
Find a car manual for your car
© 1999 - 2018 2CarPros, Inc.