1999 Chrysler Sebring Number 8 fuse keeps blowing

COREYSTOREY

MEMBER
1999 CHRYSLER SEBRING
6 CYL
FWD
AUTOMATIC
110,000 MILES

Replaced starter thinking that was it. This 20 amp fuse goes to fuel pump too, but it only blows when actually trying to start. Also, the reason I replaced the starter is because when I disconnected the wire going to the starter solenoid, the fuse did not blow when putting ignition in start like it did before. Anything else I can check? Does anyone have a wiring diagram that shows what else is on that circuit? Thanks.

2 Replies

ZACKMAN

MECHANIC
4,202 POSTS

My diagram shows #8 goes to these parts.

Wait... You must have the convertible. Convertible has this diagram.

I would check your wiring to the ignition switch. The short circuit is around there.

SPONSORED LINKS

Was this

answer

helpful?

Yes

No

+1

Sunday, March 1st, 2009 AT 11:58 PM

MRCOONASS

MEMBER
1 POST

This seems to be a common problem.(20amp #8) I just had the same problem with my 1998. A guy on another board moves his car when the problem reoccurs. That doesn't make any sense since the starter doesn't move when you roll the car. But it worked for me. 1 day when I'm bored and want to spend my time and money I will replace the starter or at least the solenoid.

Was this

answer

helpful?

Yes

No

-2

Wednesday, October 5th, 2011 AT 4:49 PM