replaced disributor but didnt mark it when i took it out so know having hard time getting it timed. need help.
Jan 8, 2013 at 5:40 AM
1999 CHEVROLET TAHOE
ANONYMOUS
- MEMBER
- 1 POST
- FOLLOW
Advertisement
need to bring it up to top dead center, compression stroke, then insert with rotor pointing to number 1 in the cap.
then you need a scan tool to set the degree to 0.
Roy
then you need a scan tool to set the degree to 0.
Roy
Jan 8, 2013 at 9:14 AM
Advertisement
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.