BECOME A MEMBER
Sign up with Facebook
I agree to the
Login with Facebook
NOT A MEMBER?
I have put new brake lines, pads, and calapiers.
1999 CHEVROLET SUBURBAN
I have put new brake lines, pads, and calapiers on my SUV and it still pulls to the left when I apply the brakes. What could be going wrong?
Saturday, March 23rd, 2013 AT 2:08 PM
Did you check the tie rod ends and that hub assembly? You could be having a problem with either of them and that would cause a pull when you brake.
Saturday, March 23rd, 2013 AT 2:12 PM
to post a reply.
Related Brake Line Content
1993 Chevy Suburban Rear Brakes
I Recently Purchased A 1993 Chevy Suburban K1500. There Was A Small Leak In The Rear Passenger Side Brake Line Whereupon I Replaced The Line...
Instructional repair video
1999 Chevy Suburban Low Brake Pedal
Brakes Problem 1999 Chevy Suburban V8 Four Wheel Drive Automatic 184k Miles I Had A Rear Wheel Cylinder Seal Failure. The Pedal...
1999 Chevrolet Suburban Braking System Leak
2 Nights Ago, My Brake Petal Was Easier To Push Than Normal And I Had To Push Down On The Brake Petal A Little Harder Than I Usually Do In...
1999 Chevy Suburban No Power Steering Or Brakes
After Sharp U-turn Lost All Power Brakes And Steering In My 6.5 Sub. Fluid All Topped Off. Presumably I Need A New Power Steering Pump....
Best Replacement Brake Rotors
I Have A 1999 Suburban What Is The Best Replacement Brake Rotors. We Do Alot Of Mountain Roads And Looking To Find Something That Will Last.
Bad gas milagr
Ask a Car Question. It's Free!
Bleed and Flush
Bleed and Flush Your Brake System Correctly
How to Bleed and Flush Your Vehicle Brakes
Find a car manual for your car
Terms & Conditions
© 1999 - 2018 2CarPros, Inc.