IN REPLACING RIGHT SIDE DRIVE AXLE I HAVE ...

  • Tiny
  • Anonymous
  • 1998 TOYOTA SIENNA
  • 31,100 MILES

In Replacing right side drive axle, I have disconnected the axle from hub, removed intermediate shaft retaining bolt and spring clip. My manuel says at this point that I sholud be able to pull out the spline joint from the transmission case. It doesnt come out. What can I do to finish removing the axle?

Saturday, February 9th, 2013 AT 8:22 PM

1 Reply

  • Tiny
  • Mhpautos
  • EXPERT
  • 30,747 POSTS

It is held in with a clip on the end of the spline, if you use a suitable small lever carefully pry between shaft and transmission an it will pop out.

Was this
answer
helpful?
Yes
No
Saturday, February 9th, 2013 AT 9:51 PM

Please login or register to post a reply.

Other Transmission Case Replace/Remove Questions