1998 ford explorer need to identify coolant by pass hose in which to install "T" fitting to flush coolant
Aug 13, 2011 at 1:27 PM
cooling system
1998 FORD EXPLORER
JOHN HO10
- MEMBER
- 46 POSTS
- FOLLOW
Advertisement
There should be a hose that goes from the firewall area to the engine block. It is about the size of a garden hose. This is normally the hose that is used to install the T fitting. Just a note of warning though...these fittings pretty much always start to leak. I really would not advise using them. I would just drain and fill your cooling system.
Sep 9, 2011 at 9:07 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.