No start

Tiny
WPB
  • MEMBER
  • 1997 CHRYSLER CONCORDE
  • 6 CYL
  • FWD
  • AUTOMATIC
  • 160,000 MILES
Where to troubleshoot next for no start situation when starter is good and battery is good
Do you
have the same problem?
Yes
No
Friday, March 25th, 2011 AT 8:47 PM

2 Replies

Tiny
CARADIODOC
  • EXPERT
What are the symptoms?
Was this
answer
helpful?
Yes
No
Friday, March 25th, 2011 AT 9:17 PM
Tiny
RASMATAZ
  • MEMBER
Pick your symptoms below check it and get back with some testing results

**Cranks but no start condition:

Get a helper disconnect a sparkplug wire or 2 and ground it to the engine at least 3/16 away from ground -have helper crank engine over-do you have a snapping blue spark? If so-you have a fuel related problem, Do you hear the fuel pump come On when you turn key on? If not check fuel pump fuse and fuel pump relay if so, check the fuel pressure to rule out the fuel filter/fuel pump/pressure regulator and listen to the injector/s are they pulsing or hook up a noid light. No snapping blue spark continue to troubleshoot the ignition system-power input to the coil/coil packs, coil's resistances, distributor pick-up coil, ignition control module, cam and crank sensors and computer Note: If it doesn't apply disregard it.

**No crank at all/nothing/nada when key is engage to starting position

Could be a blown fusible link, the starter, starter relay, clutch switch/park and neutral switch/transmission position switch and ignition switch assuming the battery condition and connections are good. Note:If it doesn't apply disregard.
Was this
answer
helpful?
Yes
No
Friday, March 25th, 2011 AT 10:06 PM

Please login or register to post a reply.

Recommended Guides