SPONSORED LINKS

Why does 1997 Chevy Tahoe run fine at idle-but backfires and runs rough while driving?

Tiny
DEBOHALLO
  • MEMBER
  • 1997 CHEVROLET TAHOE
  • 176,000 MILES
Cannot go over 20 mph or it will bog down and die out. We replaced the fuel filter, plugs, plug wires, and upper crank position sensor. We also had the ignition control module tested and it checked out good. We ran some seafoam through because water was coming out of exhaust. Nothing has made a difference-please tell me what to try next?
SPONSORED LINKS
Tuesday, February 21st, 2012 AT 12:20 AM

14 Replies

Tiny
BILLYMAC
  • MECHANIC
  • 2,204 POSTS
Two possibilities fuel pump or timeing chain. I would check these both.
Was this
answer
helpful?
Yes
No
+3
Tuesday, February 21st, 2012 AT 12:24 AM
Tiny
DEBOHALLO
  • MEMBER
  • 8 POSTS
Can you tell me how to check both?
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Tuesday, February 21st, 2012 AT 12:26 AM
Tiny
DEBOHALLO
  • MEMBER
  • 8 POSTS
Because it runs well at idle I did not think fuel pump
Was this
answer
helpful?
Yes
No
Tuesday, February 21st, 2012 AT 12:27 AM
Tiny
DEBOHALLO
  • MEMBER
  • 8 POSTS
I just asked-and the fuel pressure was checked while the vehicle was running-and it was 60 lbs pressure
Was this
answer
helpful?
Yes
No
+1
Tuesday, February 21st, 2012 AT 12:31 AM
Tiny
BILLYMAC
  • MECHANIC
  • 2,204 POSTS
Yes but it requires less fuel delivery at idle when you accelerate more volume is required the bogg and backfire together really to me seems like fuel delivery prob. This is just something that should be checked not common for a fuel pump to act this way, but I have seen it.

Another possibility is a restricted exhaust system
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Tuesday, February 21st, 2012 AT 12:32 AM
Tiny
DEBOHALLO
  • MEMBER
  • 8 POSTS
Do you think it could be the distributor cap?
Was this
answer
helpful?
Yes
No
+1
Tuesday, February 21st, 2012 AT 1:00 AM
Tiny
BILLYMAC
  • MECHANIC
  • 2,204 POSTS
Yes it is a possibility that the distributor cap or rotor has failed cracked I thought you had tuned it up sorry my mistake. So fuel pressure is ok now we have to believe it is electrical I would replace that cap and rotor so it can be eliminated.
Was this
answer
helpful?
Yes
No
-1
Tuesday, February 21st, 2012 AT 1:04 AM
Tiny
DEBOHALLO
  • MEMBER
  • 8 POSTS
We did replace the rotor-not the distributor cap. Today we replaced the crank position sensor-the first one we replaced was the cam position sensor. It seems to have more power-but still backfires. There is a lot of condensation coming from the exhaust-even though we previously ran seafoam through it
Was this
answer
helpful?
Yes
No
Wednesday, February 22nd, 2012 AT 12:05 AM
Tiny
DEBOHALLO
  • MEMBER
  • 8 POSTS
The code is P1345-which is cam sensor/crank sensor correlation-but both of the sensors are new
Was this
answer
helpful?
Yes
No
Wednesday, February 22nd, 2012 AT 12:07 AM
Tiny
BILLYMAC
  • MECHANIC
  • 2,204 POSTS
This sounds like a timeing chain. Olease repost your question and hopefully our gm guys can help
Was this
answer
helpful?
Yes
No
+1
Wednesday, February 22nd, 2012 AT 12:35 AM
Tiny
DEBOHALLO
  • MEMBER
  • 8 POSTS
If it is timing chain-would it still run well at idle? Thanks for all your help
Was this
answer
helpful?
Yes
No
Wednesday, February 22nd, 2012 AT 12:39 AM
Tiny
BILLYMAC
  • MECHANIC
  • 2,204 POSTS
Yes it could if chain is stretched beyond the parimeters of the cam and crank sensor. Just normally when nothing else makes sense it ends up being a chain prob. If you take the dist cap off and turn the crank pulley and see how much the eng has to turn before the rotor moves that will tell you how much play is in the chain.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Wednesday, February 22nd, 2012 AT 12:47 AM
Tiny
DAVIDLWELLS
  • MEMBER
  • 4 POSTS
I have a 1998 Tahoe 5.7 engine. Sometimes when at idle will run rough and backfire. If you attempt to drive it you have to pat the gas. It will not go up a hill without patting gas. Other times it runs great. I have replaced fuel pump plugs wires cap rotor button crank sensor. All 4 O2 sensors. PCM. Timing chain is new. This engine was in another vehicle and run great with no problems. Fuel pressures are good. I'm at a loss on what is going on with it. Any ideas to help will be appreciated.
Was this
answer
helpful?
Yes
No
+1
Thursday, August 13th, 2020 AT 8:20 PM
Tiny
DANNY L
  • MECHANIC
  • 5,648 POSTS
Hello, I'm Danny.

You've attached a reply to a question that is years old. What we ask you to do is start a new question and include all your vehicles information. Here is the link:

https://www.2carpros.com/questions/new

Hope this helps and we'll be looking forward to hearing from you.Thanks for using 2CarPros.
Was this
answer
helpful?
Yes
No
-1
Friday, August 14th, 2020 AT 12:07 AM

Please login or register to post a reply.

Related Engine Runs Rough Content

Code Read Retrieval/Clear Chevrolet
VIDEO
Code Read Retrieval/Clear Chevrolet
Instructional repair video
Check Engine Light
GUIDE
Check Engine Light
Why is my check engine or service engine soon turned on? In this guide we talk about what this is associated with this notorious light, what it is used for and what you...
VIEW MORE

Sponsored links