1997 Chevrolet Cavalier Replacing Crankshaft Sensor Broke Off Get Out Motor Put

1997 CHEVROLET CAVALIER
164,000 MILES
Avatar
MARCYSEELEY
  • MEMBER
  • 1 POST
i was replacing the crankshaft sensor and it broke off how can i get it out of the motor so i can put the new one in
Jan 7, 2013 at 1:24 PM
Advertisement
Avatar
WRENCHTECH
  • CAR REPAIR CONTRIBUTOR
  • 20,761 POSTS
That's going to be a big problem now. About the only way now is to drill a hole in the center and thread a screw into it, then use a gum cutter to try to loosen it up until you can pull it out with the screw.
Jan 7, 2013 at 2:09 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.