96 VW Jetta GL-how to change a rear turn signal bulb
Apr 4, 2011 at 5:04 PM
changing a rear turn signal bulb
1996 VOLKSWAGEN JETTA
LSTOCKDA66
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
Open the trunk and you will find wing nuts that hold the light assembly in place. Remove the wing nuts and light assembly to access the bulbs.
Jul 3, 2011 at 5:43 AM
Advertisement
I know this is an old post, but in case someone else is reading this...
Here' the real way:
- Open trunk
- Pull trunk liner to side to gain access to light assembly in trunk
- Find the 2 tabs opposite each other and "squeeze" them together
- Pull the bulb holder circuit board out of the light assembly
- Remove faulty bulb (push in on bulb and turn counterclockwise)
- Install new bulb
- Push Circuit board back into place until you hear 2 clicks
- Put trunk liner back in place
Thomas
Here' the real way:
- Open trunk
- Pull trunk liner to side to gain access to light assembly in trunk
- Find the 2 tabs opposite each other and "squeeze" them together
- Pull the bulb holder circuit board out of the light assembly
- Remove faulty bulb (push in on bulb and turn counterclockwise)
- Install new bulb
- Push Circuit board back into place until you hear 2 clicks
- Put trunk liner back in place
Thomas
Mar 11, 2012 at 11:07 PM