I need to replace the studs on a 1996 Honda Accord and the knuckle will not move, is the knuckle staked?
Tuesday, November 30th, 2010 AT 10:15 PM
2 Replies
KHLOW2008
MECHANIC
41,815 POSTS
The hub is press fitted onto the wheel bearings and is secured by the CV joint central nut. After removal of the nut you need a hpuller to pull the hub out.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Thursday, December 2nd, 2010 AT 3:22 PM
CHARLESCARVER
MEMBER
1 POST
Ok I have just about the same problem where is this nut you speek of located?Is it behind the whole wheel asslebmly?