SAAB HAS NO POWER AFTER REPLACING IGNITION SWTICH

  • Tiny
  • nkd1303
  • 1995 SAAB 900
  • 4 CYL
  • FWD
  • manual
  • 100 miles

1995 Saab SE Turbo. Replaced ignition switch, still wont start. No power, no lights, no nothing.
Replaced it following this diagram.... http://photo.platonoff.com/Auto/20070617a.Saab_NG900_Shifter_Housing_Removal/?all

Do you
have the same problem?
Yes
No
Thursday, July 14th, 2011 AT 1:56 AM

2 Replies

  • Tiny
  • rasmataz
  • Member

Check and test maxi fuse no.3 60amp this is the one that powers the ignition switch

Was this
answer
helpful?
Yes
No
Thursday, July 14th, 2011 AT 2:40 AM
  • Tiny
  • mnthny4
  • Expert
  • 616 posts

U replaced the wrong part what u need is the module under your drivers seat mount to the floor under the carpet, this module is called the [ICE module ] replace that and u r good to go, good luck. Note module will need programming to work properly, u can also buy used from this place called goldwing saab, check web for there contact info.

Was this
answer
helpful?
Yes
No
Wednesday, July 20th, 2011 AT 12:25 PM

Please login or register to post a reply.

Similar Questions