I have a 1995 Ford Bronco and my breaks wont.

Tiny
JVILL1322
  • MEMBER
  • 1995 FORD BRONCO
  • 125,000 MILES
I have a 1995 ford bronco and my breaks wont work ive replaced the front rotors, calibiers, pads, as well as the rear drums and shoes, ive also replaced the master cylinder and the booster and I still have no breaks. What the problem?
Do you
have the same problem?
Yes
No
Sunday, October 28th, 2012 AT 7:11 PM

7 Replies

Tiny
ASEMASTER6371
  • EXPERT
Did you have it pressure bled to rid it of air?

What was the original issue?

Roy
Was this
answer
helpful?
Yes
No
Sunday, October 28th, 2012 AT 7:14 PM
Tiny
JVILL1322
  • MEMBER
I was just replacing my breaks and I just bled them when I put the new ones on.
Was this
answer
helpful?
Yes
No
Sunday, October 28th, 2012 AT 7:27 PM
Tiny
ASEMASTER6371
  • EXPERT
So you had brakes prior to this repair?

Start with pressuring bleeding system

Roy
Was this
answer
helpful?
Yes
No
Sunday, October 28th, 2012 AT 7:28 PM
Tiny
JVILL1322
  • MEMBER
Yes I did but they where really bad and need to be replaced. Ok and how would I do that do I have to take it to a shop?
Was this
answer
helpful?
Yes
No
Sunday, October 28th, 2012 AT 7:30 PM
Tiny
ASEMASTER6371
  • EXPERT
You can rent the bleeder from a parts store.

Roy
Was this
answer
helpful?
Yes
No
Sunday, October 28th, 2012 AT 7:32 PM
Tiny
JVILL1322
  • MEMBER
Ok some told me that it might be the abs hydrolic unit but the one the sold me at autozone looks nothing like the original? Could the old one be the problem
Was this
answer
helpful?
Yes
No
Sunday, October 28th, 2012 AT 7:34 PM
Tiny
ASEMASTER6371
  • EXPERT
Stop throwing parts at it that were fine before the repair.

Start with basics and get the system properly bled.

Roy
Was this
answer
helpful?
Yes
No
Sunday, October 28th, 2012 AT 7:35 PM

Please login or register to post a reply.

Recommended Guides