Ignition timing

Tiny
GEORGIA BOY
  • MEMBER
  • 1994 MAZDA PROTEGE
  • 4 CYL
  • FWD
  • AUTOMATIC
  • 116,000 MILES
How do I set the ignition timing on a 1994 mazda protege? The timing mark is way down on the crankshaft pulley. How do I know which mark is which? There is no way to read the numbers, etc. I know to use a jumper wire between the TEN and GND of the test connector. I can buy an induction timing light, but how in the world do you know which notch of the timing indicator to use? THANK YOU FOR YOUR HELP!
Do you
have the same problem?
Yes
No
Sunday, February 6th, 2011 AT 12:39 PM

3 Replies

Tiny
MHPAUTOS
  • MECHANIC
  • 31,938 POSTS
You need to use a timing light on the front balancer here are the instruction in the diagrams below click to enlarge. Check out the diagrams (Below). Please let us know if you need anything else to get the problem fixed.

Cheers
Was this
answer
helpful?
Yes
No
+1
Sunday, February 6th, 2011 AT 1:04 PM
Tiny
GEORGIA BOY
  • MEMBER
  • 2 POSTS
Thank you!
Was this
answer
helpful?
Yes
No
-1
Sunday, February 6th, 2011 AT 1:52 PM
Tiny
MHPAUTOS
  • MECHANIC
  • 31,938 POSTS
If you need any further assistance re post at any time, thank you for using 2carpros.

Mark (mhpautos)
Was this
answer
helpful?
Yes
No
Sunday, February 6th, 2011 AT 2:00 PM

Please login or register to post a reply.

Sponsored links