BECOME A MEMBER
Sign up with Facebook
I agree to the
Login with Facebook
NOT A MEMBER?
94 Rodeo CKP LOCATION
1994 ISUZU RODEO
Starts and idles perfect. When the accelarater is pressed it almost dies. Wont go over 2200 rpm
have the same problem?
Friday, December 16th, 2011 AT 9:55 AM
Go to this link:
Could be caused by one of the following below
Fuel injectors dirty/sticking.
Mass airflow sensor/Airflow meter.
Throttle position sensor.
Crankshaft position sensor
Manifold absolute pressure sensor.
Fuel pressure regulator leaking or defective fuel pump.
Foul/defective spark plugs.
Open spark plug wires.
Ignition coil/Coil packs defective.
Incorrect ignition timing.
Cap and rotor.
Note:If it doesn't apply disregard it and keep testing.
Friday, December 16th, 2011 AT 10:31 AM
to post a reply.
Related Crankshaft Crankshaft Sensor Location Content
1994 Isuzu Rodeo Question Location Of Sensors
Electrical Problem 1994 Isuzu Rodeo Question 6 Cyl Four Wheel Drive Automatic 150000 Miles Where Are The Cam Position And Crank Position...
My Car Is Losing Oil I Had It Ck For A Leak But Can't...
My Car Is Losing Oil I Had It Ck For A Leak But Can't Find Out Where It Is Going. I Lost 2qt In About 200 Miles, There Is No Oil On The...
1994 Isuzu Rodeo Question Crankshaft Position Sensor
Electrical Problem 1994 Isuzu Rodeo Question 6 Cyl Four Wheel Drive Automatic 150000 Miles I Appriciate Your Rapid Resposne To My...
Throttle Rev Limiter And Air Intake
How Do I Stop My Rev Limiter And Does Air Flow Actuate The Four Wheel Drive
1994 Isuzu Rodeo Question Timing Belt
1994 Isuzu Rodeo Question 6 Cyl Four Wheel Drive Automatic I Recently Did Some Repairs On My Truck And The People That Helped Me Threw...
Ask a Car Question. It's Free!
Engine Will Not Start
Code Read Chevrolet Blazer 1995-2005
Find a car manual for your car
© 1999 - 2017 2CarPros, Inc.