BECOME A MEMBER
Sign up with Facebook
I agree to the
Login with Facebook
NOT A MEMBER?
I had the trasmission replaced on a 94 Chrysler Concorde and now the mechanic can't get the car to start.
1994 CHRYSLER CONCORDE
The car started fine before replacing transmission. It just cranks but nothing else.
have the same problem?
Monday, February 6th, 2012 AT 11:38 PM
Chances are he disturbed the crank sensor. Check to see if there is spark to the engine. If not, check the crank sensor. Also, make sure the engine is getting fuel.
Monday, February 6th, 2012 AT 11:41 PM
to post a reply.
Related Transmission Replace/Remove Questions
My Transmission Doesn't Want To Shift Out Of Low Gear...
I Recently Added The Wrong Type Of Fluid (dexron) And Drove It Around For A Couple Of Weeks. It Still Drove Ok, Though It Wasn't Quite...
1994 Chrysler Concorde 1994 Chrysler Concorde...
Transmission Problem 1994 Chrysler Concorde 6 Cyl Front Wheel Drive Automatic 120000 Miles Would Putting In Too Much Transmission Fluid...
It Shifts In Low Gear And Stays There Untill I Shut Off Car. On Going Thing Drive A Few Miles And It Starts Again.
1994 Chrysler Concorde Motor Mounds And Transmission...
Other Category Problem 1994 Chrysler Concorde 6 Cyl Two Wheel Drive Automatic 92000. Miles I Need To Know The Cost For A Repair Shop...
Ask a Car Question. It's Free!
Drive Shaft Removal and Slip Yoke Service
Drive Shaft Removal - All Cars
Find a car manual for your car
© 1999 - 2017 2CarPros, Inc.